1-6Figure 1-3 The page for configuring an basic IPv4 ACLTable 1-6 describes the configuration items for creating a rule for a basic IPv4 ACL.Table 1-6 Configuration items for a basic IPv4 ACL ruleItem DescriptionSelect Access Control List (ACL) Select the basic IPv4 ACL for which you want to configure rules.Available ACLs are basic IPv4 ACLs that have been configured.Rule IDSelect the Rule ID option and type a number for the rule.If you do not specify the rule number, the system will assign oneautomatically.OperationSelect the operation to be performed for IPv4 packets matchingthe rule.z Permit: Allows matched packets to pass.z Deny: Drops matched packets.Check FragmentSelect this option to apply the rule to only non-first fragments.If you do no select this option, the rule applies to all fragmentsand non-fragments.Check LoggingSelect this option to keep a log of matched IPv4 packets.A log entry contains the ACL rule number, operation for thematched packets, protocol that IP carries, source/destinationaddress, source/destination port number, and number ofmatched packets.Source IP AddressSource WildcardSelect the Source IP Address option and type a source IPv4address and a wildcard mask, in dotted decimal notation.
