1-4Item DescriptionStreamOrientationSet the direction of the traffic monitored by the monitor port of the mirroring groupThis configuration item is available when Mirror Port is selected is the Port Typedrop-down list.z both: Mirrors both received and sent packets on mirroring ports.z inbound: Mirrors only packets received by mirroring port.z outbound: Mirrors only packets sent by mirroring ports.Select port(s) Click the ports to be configured on the chassis front panel.Return to Local port mirroring configuration task list.Configuration ExamplesLocal Port Mirroring Configuration ExampleNetwork requirementsThe customer network is as described below:z Department 1 accesses Switch C through GigabitEthernet 1/0/1.z Department 2 accesses Switch C through GigabitEthernet 1/0/2.z Server is connected to GigabitEthernet 1/0/3 of Switch C.Configure port mirroring to monitor the bidirectional traffic of Department 1 and Department 2 on theserver.To satisfy the above requirement through local port mirroring, perform the following configuration onSwitch C:z Configure GigabitEthernet 1/0/1 and GigabitEthernet 1/0/2 as mirroring ports.z Configure GigabitEthernet 1/0/3 as the monitor port.Figure 1-4 Network diagram for local port mirroring configurationConfiguration procedure# Create a local mirroring group.Select Device > Port Mirroring from the navigation tree and click Create to enter the page for creatingmirroring groups, as shown in Figure 1-5.
