Function Library 1676.15 Position Compare and Latch@ Name_8102_set_trigger_logic – Set the CMP signal’slogic_8102_set_trigger_comparator – Set the triggercomparator_8102_set_error_comparator – Set the errorcomparator_8102_set_general_comparator – Set the generalcomparator_8102_set_latch_source – Set the latch timing fora counter_8102_set_ltc_logic – Set the logic of LTC signal_8102_get_latch_data – Get the latch datas fromcounter@ Description_8102_set_trigger_logic:This function is used to set the logic of CMP single._8102_set_error_comparator:This function is used to set the comparing method and value forthe error comparator. When the position error counter’s valuereaches the comparing value, the 8102 will generate an interruptto the host PC. Also see section 6.14 “Interrupt control”._8102_set_general_comparator:This function is used to set the comparing source counter, com-paring method and value for the general comparator. When thecomparison conditions are met, there is one of the 4 reactions willbe done. The detail setting, see the argument discribtion._8102_set_trigger_comparator:This function is used to set the comparing source counter, com-paring method and value for the trigger comparator. When thecomparison source counter’s value reaches the comparing value,the 8102 will generate a pulse output via CMP and an interrupt(event_int_status, bit 12) will also be sent to host PC._8102_set_latch_source:
