Installation 112.3 PCI-8102 Hardware Installation2.3.1 Hardware ConfigurationThe PCI-8102 is fully Plug and Play compliant. Hence memoryallocation (I/O port locations) and IRQ channel of the PCI card areassigned by the system BIOS. The address assignment is doneon a board-by-board basis for all PCI cards in the system.2.3.2 PCI Slot SelectionYour computer system may have both PCI and ISA slots. Do notforce the PCI card into a PC/AT slot. The PCI-8102 can be used inany PCI slot.2.3.3 Installation Procedures1. Read through this manual and setup the jumper accord-ing to your application2. Turn off your computer. Turn off all accessories (printer,modem, monitor, etc.) connected to computer. Removethe cover from your computer.3. Select a 32-bit PCI/PXI expansion slot. PCI slots areshorter than ISA or EISA slots and are usually white orivory.4. Before handling the PCI-8102, discharge any staticbuildup on your body by touching the metal case of thecomputer. Hold the edge of the card and do not touchthe components.5. Position the board into the PCI slot you have selected.6. Secure the card in place at the rear panel of the systemunit using screws removed from the slot.
