61200659L1-1 MX2800 STS-1 User Manual Index-1IndexNumerics10BaseT connection, location of 2-724 Hour Alarm HistoryDS3 Statistics menu 5-2AAcknowledge Alarms (ACO) menu 4-12acknowledgment messages 9-2All Right 9-3In Progress 9-3ACO buttons 2-12ACT LED, active cards 2-14ACT LED, standby cards 2-15Active Controller menu 3-5Active state, Card A/Card B 4-6AFE PROGRAM FAILURE 3-39agent, SNMP 1-6alarm connectors, MX2800 2-8alarm events 9-10Alarm menuSystem State 4-5alarm trapsDS2 3-30DS3 (near-end active and standby cards) 3-26power supply 3-33alarmsDS2 3-21DS3 3-19power supply, alarm relay 3-24power supply, trap community name 3-33system 3-23ALM LED, active cards 2-14ALM LED, standby cards 2-15Amp connector pin assignments A-3Analog Network loopback test 6-3Answer on Ring menu 3-16Authentication Failure, MIB II Standard AlarmTraps 3-34autonomous messages 9-4 , 9-10, 9-12Bbackup protection 8-1battery backup mode 8-5non-redundant power mode 8-2power supply and source recovery mode 8-4power supply recovery mode 8-3backup T3, routing information to 3-6BAD BOOT SECTOR 3-39BAD CODE CHECKSUM 3-39BAD RAM ADDRESS 3-39BAD RAM DATA 3-39battery backup mode 8-5battery backup, overview 1-8Battery LowPower Supply Alarm 3-24Power Supply Alarm Trap 3-34Power Supply State 4-5baud rate, setting 3-17BERTCSU Loopback w/ 6-5Line 6-6breakout panelconnecting 2-6
