Chapter 3. Configuration61200659L1-1 MX2800 STS-1 User Manual 3-43System ResetThe system must be manually reset after downloading newsoftware. When the unit has successfully loaded and programmedthe new software into its FLASH memory, it will begin uploadingthe code to the stand-by controller. This will be indicated on themenu and the STATUS LED on the stand-by card will display solidyellow.Once the upload is complete, the stand-by card will self-reset andbegin running the new code. However, the active card does notreset automatically. The unit must be reset through the IMMEDIATER ESET or S CHEDULED R ESET T IME functions.SAVE CONFIGURATIONCommits the current configuration changes to nonvolatile memory.If this option is not selected after making changes to theconfiguration, the unit reverts to its previous configuration whenpowered down.The stand-by card must remain in place until the process iscomplete and the STATUS LED is no longer solid yellow.Removing the stand-by card during the uploading process willcorrupt the software.
