Command Reference Guide Enable Mode Command Set61200990L1-35E Copyright © 2005 ADTRAN 179show frame-relayUse the show frame-relay command to display configuration and status parameters for configured virtualFrame Relay interfaces.Variations of this command include the following:show frame-relay lmishow frame-relay pvcshow frame-relay pvc interface frame-relay show frame-relay pvc realtimeSyntax Descriptionlmi Displays Link Management Interface (LMI) statistics for each virtual Frame Relayinterface.pvc Displays Permanent Virtual Circuit (PVC) configuration and statistics for all virtualFrame Relay interfaces (or a specified interface).frame-relay Optional. Displays Frame Relay PVC statistics for a specific Frame Relayinterface. Specifies the virtual Frame Relay interface (for example fr 1).realtime Displays full-screen output in realtime. See the Functional Notes below for moreinformation.Default ValuesNo default value necessary for this command.Applicable PlatformsThis command applies to the NetVanta 1000R, 3000, 4000, and 5000 and Total Access 900 Series units.Command HistoryRelease 1.1 Command was introduced.Release 10.1 Realtime option was introduced.Functional NotesUse the realtime argument for this command to display full-screen output in real time. Information iscontinuously updated on the console until you either freeze the data (by pressing the F key) or exitrealtime mode (by pressing Ctrl-C). If there is not enough room on the screen for all available data, theinformation will truncate at the bottom of the screen. In order to maximize the amount of data displayed,increase the terminal length (using the terminal length command; refer to terminal length on page276).
