Command Reference Guide T1 Interface Configuration Command Set61200990L1-35E Copyright © 2005 ADTRAN 603T1 INTERFACE CONFIGURATION C OMMAND S ETTo activate the T1 Interface Configuration mode, enter the interface t1 command at the GlobalConfiguration mode prompt. For example:>enable#configure terminal(config)#interface t1 1/1(config-t1 1/1)#The following commands are common to multiple command sets and are covered in a centralized sectionof this guide. For more information, refer to the sections listed below:alias <“text”> on page 27cross-connect <#> on page 28description on page 31do on page 32end on page 33exit on page 34shutdown on page 35All other commands for this command set are described in this section in alphabetical order.clock source [internal | line | through | through ] on page 604coding [ami | b8zs] on page 605fdl [ansi | att | none] on page 606framing [d4 | esf] on page 607lbo [long <-22.5, -15, -7.5, 0> | short <0-655>] on page 608loopback commands begin on page 609remote-alarm [rai] on page 612remote-loopback on page 613show test-pattern on page 614snmp trap line-status on page 615snmp trap link-status on page 616snmp trap threshold-reached on page 617tdm-group timeslots <1-24> speed [56 | 64] on page 618test-pattern [clear | insert | ones | p215 | p220 | p511 | qrss | zeros] on page 619
