Command Reference Guide Global Configuration Mode Command Set61200990L1-35E Copyright © 2005 ADTRAN 338event-history priority [error | fatal | info | notice | warning]Use the event-history priority command to set the threshold for events stored in the event history. Allevents with the specified priority or higher will be kept for viewing in the local event log. The event logmay be displayed using the show event-history command. Use the no form of this command to keepspecified priorities from being logged.Syntax DescriptionSets the minimum priority threshold for logging messages to the event history. The following priorities areavailable (ranking from lowest to highest):error Logs events with error and fatal priorities.fatal Logs only events with a fatal priority.info Logs all events.notice Logs events with notice, warning, error, and fatal priorities.warning Logs events with warning, error, and fatal priorities.Default ValuesBy default, no event messages are logged to the event history.Applicable PlatformsThis command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 andTotal Access 900 Series units.Command HistoryRelease 1.1 Command was introduced.Functional NotesThe event history provides useful information regarding the status of the system and individual port states.Use the event history as a troubleshooting tool when identifying system issues. The following is a sampleevent history log.Router#show event-historyUsing 526 bytes2002.07.12 15:34:01 T1.t1 1/1 Yellow2002.07.12 15:34:01 INTERFACE_STATUS.t1 1/1 changed state to down.2002.07.12 15:34:02 T1.t1 1/1 No Alarms2002.07.12 15:34:02 INTERFACE_STATUS.t1 1/1 changed state to up.2002.07.12 15:34:03 INTERFACE_STATUS.eth 0/1 changed state to up.2002.07.12 15:34:10 OPERATING_SYSTEM Warm Start2002.07.12 15:34:12 PPP.NEGOTIATION LCP up2002.07.12 15:34:12 PPP.NEGOTIATION IPCP up
