Command Reference Guide Global Configuration Mode Command Set61200990L1-35E Copyright © 2005 ADTRAN 442router pim-sparseUse the router pim-sparse command to globally enable protocol-independent multicast (PIM) on the unitand to enter the PIM Sparse Configuration mode. Refer to the section Router (PIM Sparse) ConfigurationCommand Set on page 834 for more information on the subcommands for PIM Sparse Configurationmode.Syntax DescriptionNo subcommands.Default ValuesNo default values necessary for this command.Applicable PlatformsThis command applies to the NetVanta 2000 and 5000 and Total Access 900 Series units.Functional NotesAdditional commands for PIM are found in the related interface configuration modes. See theip pim-sparse commands in sections such as Ethernet Interface Configuration Command Set on page527, Frame Relay Sub-Interface Config Command Set on page 714, HDLC Command Set on page 782,Loopback Interface Configuration Command Set on page 846, PPP Interface Configuration Command Seton page 883, Tunnel Configuration Command Set on page 967, and VLAN Interface Config Command Seton page 668 for more information.Command HistoryRelease 11.1 Command was introduced.Usage ExamplesThe following example uses the router pim-sparse command to enter the PIM Sparse Configurationmode:(config)#router pim-sparse(config-pim-sparse)#
