Command Reference Guide T3 Interface Configuration Command Set61200990L1-35E Copyright © 2005 ADTRAN 620T3 INTERFACE CONFIGURATION C OMMAND S ETTo activate the T3 Interface Configuration mode, enter the interface t3 command at the GlobalConfiguration mode prompt. For example:>enable#configure terminal(config)#interface t3 1/1(config-t3 1/1)#The following commands are common to multiple command sets and are covered in a centralized sectionof this guide. For more information, refer to the sections listed below:alias <“text”> on page 27cross-connect <#> on page 28description on page 31do on page 32end on page 33exit on page 34shutdown on page 35All other commands for this command set are described in this section in alphabetical order.clock source [local | loop] on page 621coding [b3zs] on page 622framing [m13 | cbit] on page 623line-length [short | long] on page 624loopback network [line | payload] on page 625loopback remote [line | payload] on page 626remote-loopback on page 627show [bert] on page 628snmp trap link-status on page 629test-pattern [clear | insert | ones | p215 | p223 | zeros] on page 630
