4-10DuraLAN Fast Ethernet NICs User’s Guide6 When you are done, click OK. You will return to the Adapterstab of the Network window. indicates thatPort 2 is the backup port for Port 1.Note: The Adapters tab identifies one model only, evenwhen several DuraLAN NIC models are installed. TheDuraLAN NIC model displayed is the same as the firstmodel you chose in Step 8 during the driver installation.7 When you are done, click Close. You will return to theNetwork Settings window.8 If SNMP is not set up on your computer, you will receive theSetup Message below. Ignore the message, and click OK.9 Enter the protocol information. Consult your MicrosoftWindows NT 4.0 documentation for help configuring theprotocol (such as entering values for TCP/IP).10 Remove the CD from the CD-ROM drive.11 Restart the system.Note: If you were required to insert the Windows NT CD,you must reinstall the latest version of Microsoft WindowsNT Service Pack, then restart the system.Monitoring Failover Pairs in Windows NT 4.0There are three ways to monitor the status of the Failover pairs: SNMP Manager—When Failover occurs, SNMP traps are sentto network management stations and error logs are updatedthrough the OS event log. In order to manage SNMP agents,compile the following .mib file on the SNMP managementstation:a:\snmpmibs\duralink.mib
