IPNext 190 System Installation GuideAddPac Technology Proprietary & Documentation 132 - 269 If a static prevention waist strap is available, strap it around the wrist and earth the cord beforeoperating the equipment.9 If no waist tap is available, stand on the ground and hold a metal part of the chassis will help preventstatic electricity.Site Requirements in GeneralThe IPNext190 is ready for use where electronic products are used. However, a location with the followingconditions is recommended for the maximum performance.z A level and well ventilated location is recommended.z Secure the equipment safely where intended to install.z Avoid placing objects on top of the equipment.z Install the equipment in a cool location avoiding direct sunlight.z Maintain distance from flammable, chemical, or magnetic objectsRequired Tools and EquipmentThis procedure is to follow EIA standards and other EMI regulations when you install the gatewayThe following section describes the Ethernet Cable, and the Console Cable which can be connected to theIPNext190.Some cables and equipment are not included and your need to purchase them separately. Please prepare thefollowing tools and equipmentz A standard screw driver setz The cables to connect LAN and console portz RJ-45 to RJ-45 connection type for LAN portz RS-232C cable type for console with RJ-45 connector type (included in the package)z Ethernet PortThe IPNext PBX Series have two RJ-45 types of Ethernet ports on the rear panel and also has LEDsindication the port status. Use the standard cable and connector types of this port to access LAN. Refer toAppendix B for pin details for the Ethernet cable.
