IPNext 190 System Installation GuideAddPac Technology Proprietary & Documentation 132 - 70ftp serverFTP is enabled at the default setting and it can be enabled when it is necessary. ftp server command isenabled at TCP21.FTP is disabled at the default setting and it can be enabled depending on its necessity. The ftp servercommand enables ftp on the port number TCP21. Use ftp allow anonymous command to configure the openftp server. The user account for accessing ftp is configured by username command. The following exampleenables ftp server and allowing access for the anonymous account.Table 3-46 FTP Server ConfigurationStep Command Description1 IP-PBX#IP-PBX# configure terminalIP-PBX(config)#Enter APOS command entry mode2 IP-PBX(config)# ftp server Enable FTP server3 IP-PBX(config)# username rootpassword routerFTP user account. Create “root/router”4 IP-PBX(config)# ftp port 21 (Optional) Configure to change the default ftp port 215 IP-PBX(config)# ftp allowanonymous(Optional) Allowing the anonymous accountTable 3-47 Verifying FTP SettingsStep Command Description1 IP-PBX# show runBuilding configuration...Current configuration:version 8.47.024hostname IP-PBX!interface FastEthernet0/0ip address 172.20.101.100 255.255.0.0!ip route 0.0.0.0 0.0.0.0 172.20.1.1!ftp serverUse show run command to verify theenabled FTP setting details2 ideoPhone# show ip tcp portLocal Address / Port Remote Address / PortUse show ip tcp port command toverify the operational status of ftp port
