Axis 01107-004 User Manual

AXIS M5065 PTZ Network CameraAbout wireless I/O (Z-Wave Plus®)• COMMAND_CLASS_VERSIONConsiderationsBefore using wireless I/O with Z-Wave Plus, consider the following:• You need to be an administrator to do the Z-Wave configurations.• When performing Z-Wave related actions on the product’s web page, such as adding, removing and replacing Z-Wavedevices or resetting the Z-Wave network, we recommend that you do not reload the page or move away from it when theaction process is ongoing. If done, the action’s actual and displayed statuses may differ. To recover, you may need to waitup to several minutes and then reload the page again.• Replication, i.e. copying network information to another control device, is executed as part of the inclusion process.• This product ignores all commands in the Basic Command Class.• If the network primary controller is missing or otherwise inoperable, you need to reset to factory default settings from theproduct’s web page. To do this, go to Setup > System Options > Maintenance, and click Default.How to add a Z-Wave deviceThough not limited by the Z-Wave Plus protocol, your product’s event system allows you to add a maximum of six Z-Wave devicesat any given time. If the maximum number is reached, you need to remove a Z-Wave device before you can add a new one.See How to remove a Z-Wave device on page 43.1. Go to Setup > Wireless I/O.2. Select Enable Z-Wave and click Save. You may need to wait for a few minutes for Z-Wave to become active.3. Click Add. The product starts looking for Z-Wave devices in the Z-Wave network.4. Set the Z-Wave device to be added into learning (inclusion/exclusion) mode as described in its User Manual.5. If requested, enter the PIN delivered with the Z-Wave device, and click Enter.6. Wait until the adding process is finalized as indicated by Status: Done on the web page. The device’s status informationwindow opens.7. Click Refresh to update the Z-Wave device info, e.g. battery status, and add a name for the device. Click Save.The added Z-Wave device with some status information is now visible on the Z-Wave Device List.NoteIf the Z-Wave device is not found, the adding process is terminated automatically.To check the more detailed status information of the added Z-Wave device, select it from the Z-Wave Device List, and click Modify.NoteStatus information for an added Z-Wave device varies depending on the device type. Fore more information, see theonline help .You can set the product to trigger action rules with specified Z-Wave trigger conditions. The available Z-Wave triggers and actionsvary depending on the added Z-Wave device type. For more information, see How to set up action rules on page 34.42