Axis 01107-004 User Manual

AXIS M5065 PTZ Network CameraAbout wireless I/O (Z-Wave Plus®)How to remove a Z-Wave deviceHow to remove a Z-Wave device through learning modeNoteThis is the recommended removal procedure.1. Go to Setup > Wireless I/O.2. Click Remove. The product starts looking for Z-Wave devices in the Z-Wave network.3. Set the Z-Wave device to be added into learning (inclusion/exclusion) mode as described in its User Manual.4. Wait until the removal process is finalized as indicated by Status: Done on the web page.The Z-Wave device is now removed from the Z-Wave Device List.NoteAll product-related information in the removed Z-Wave device is erased.NoteIf the Z-Wave device is not found, the adding process is terminated automatically.How to remove a Z-Wave device through forced processThere may be a communication fail e.g. due to drained battery so you may not be able to remove the Z-Wave device by setting itto learning mode. You can perform a forced removal of a Z-Wave device that shows status Unavailable or Sleep in the Z-WaveDevice List.1. Go to Setup > Wireless I/O.2. Select the Z-Wave device to be removed from the Z-Wave Device List and, click Modify. The device’s status informationwindow opens.3. Click Remove.4. Click OK to confirm the removal.The Z-Wave device is now removed from the Z-Wave Device List.NoteAll product-related information in the removed Z-Wave device is retained.How to replace a Z-Wave deviceThere may be a communication fail e.g. due to a faulty Z-Wave device, and you want to replace the device with another one. You canperform a forced replacement of a Z-Wave device that shows status Unavailable or Sleep in the Z-Wave Device List.1. Go to Setup > Wireless I/O.2. Select the Z-Wave device to be replaced from the Z-Wave Device List and, click Modify. The device’s status informationwindow opens.3. Click Replace. The product starts looking for Z-Wave devices in the Z-Wave network.4. Set the Z-Wave device that is to replace the existing device into learning (inclusion/exclusion) mode as described in itsUser Manual.5. Wait until the replacement process is finalized as indicated by Status: Replacing (found node) on the web page.The new Z-wave device with some status information is now visible on the Z-Wave Device List.43