Axis 01107-004 User Manual

AXIS M5065 PTZ Network CameraAbout system optionsRTP/H.264The RTP port range and multicast settings are configured under System Options > Network > RTP.The RTP port range defines the range of ports from which the video/audio ports are automatically selected. For multicast streams,only certain IP addresses and port numbers should be used.Select Always Multicast Video and/or Always Multicast Audio to start multicast streaming without opening an RTSP session.BonjourThe Axis product includes support for Bonjour. Bonjour is enabled by default and the product is automatically detected by operatingsystems and clients that support this protocol.Bonjour can be disabled under System Options > Network > Bonjour.StorageAbout SD cardsNONONOTICETICETICETo prevent data corruption, the SD card should be unmounted before removal.NoteFor SD card recommendations see www.axis.comThe Axis product supports microSD/microSDHC/microSDXC cards.The following SD card file systems are supported:• ext4 — recommended due to its resilience against data loss if the card is ejected or if there is abrupt power loss. To accessdata stored on the card from the Windows operating system, a third-party ext4 driver or application is required.• vFAT — supported by most operating systems for personal computers.The SD card is managed on the System Options > Storage page. Click SD Card to open Storage Management.If the card’s status shows as failed, click Check disk to see if the problem can be found and then try Repair. This option is onlyavailable for SD cards with ext4. For SD cards with vFAT, use a card reader or computer to troubleshoot the card.To avoid filling the card, it is recommended to remove recordings continuously. Under General Settings, select Remove recordingsolder than and select the number of days or weeks.To stop writing to the card and protect recordings from being removed, select Lock under General Settings.How to mount and unmount the SD cardNONONOTICETICETICETo prevent corruption of recordings, the SD card should always be unmounted before it is ejected.The SD card is automatically mounted when the card is inserted into the Axis product or when the product is started. A manualmount is only required if the card has been unmounted and not ejected and re-inserted.To unmount the SD card:1. Open the Axis product’s webpages and go to Setup > System Options > Storage.2. Click SD Card.3. Click Unmount.54