Chapter 5: Local Management5-642E48-27R/2E49-27R User’s Guide5.18 BROADCAST SUPPRESSION SCREENThe Broadcast Suppression screen, Figure 5-26, allows the user to set adesired limit of receive broadcast frames that are switched out to the otherports.To access the Broadcast Suppression screen from the Device SpecificConfiguration Menu screen, use the arrow keys to highlight theBROADCAST SUPPRESSION menu item and press ENTER. TheBroadcast Suppression screen displays.Figure 5-26 Broadcast Suppression ScreenNOTEThe Broadcast Suppression screen may not be available if theoperational mode of the device is set to SECURE FAST VLAN.Refer to the Release Notes to see which operational modessupport the Broadcast Suppression screen. Section 5.7.9,Setting the Operational Mode, describes how to configure thedevice to operate in this mode.Broadcast frames received above the threshold setting aredropped.Firmware Revision: XX.XX.XXBroadcast Suppression23141-56Device Type: 2E48-27RBOOTPROM Revision: XX.XX.XXPORT #123456789101112Time Since Peak999:23:59999:23:59999:23:59999:23:59999:23:59999:23:59999:23:59999:23:59999:23:59999:23:59999:23:59999:23:59Peak Rate150000150000150000150000150000150000150000150000150000150000150000150000Threshold1500001500001500001500001500001500001500001500001500001500001500001500002E48-27R LOCAL MANAGEMENTEvent Message LineTotal RX123456789101234567891012345678910123456789101234567891012345678910123456789101234567891012345678910123456789101234567891012345678910Reset Peak[NO][NO][NO][NO][NO][NO][NO][NO][NO][NO][NO][NO]RETURNRETURNSAVE [13-24]EXIT
