General Configuration Screen2E48-27R/2E49-27R User’s Guide5-254. Use the arrow keys to highlight the SAVE command at the bottom ofthe screen and press ENTER.If the date entered is a valid format, the message displays “SAVED OK”at the top of the screen. If the entry is not valid, Local Management doesnot alter the current value, but it does refresh the Device Date field withthe previous value.5.7.6 Setting the Device TimeTo set the device time, perform the following steps:1. Use the arrow keys to highlight the Device Time field.2. Enter the time in this 24-hour format: HH:MM:SS3. Press ENTER to set the system clock to the time in the input field.4. Use the arrow keys to highlight the SAVE command at the bottom ofthe screen and press ENTER.If the time entered is a valid format, the message displays “SAVED OK”at the top of the screen. If the entry is not valid, Local Management doesnot alter the current value and refreshes the Device Time field with theprevious value.5.7.7 Entering a New Screen Refresh TimeThe screen refresh time is set from 3 to 99 seconds with a default of 3seconds. To set a new screen refresh time, perform the following steps:1. Use the arrow keys to highlight the Screen Refresh Time field.2. Enter a number from 3 to 99.3. Press ENTER to set the refresh time to the time entered in the inputfield.NOTEWhen entering the time in the system time field, separatorsbetween hours, minutes, and seconds are not needed as longas each entry uses two numeric characters. For example, to setthe time to 6:45 P .M., type “184500” in the Device Time field.
