Chapter 5: Local Management5-422E48-27R/2E49-27R User’s Guide5.11 ETHERNET FULL DUPLEX CONFIGURATIONSCREENThe Ethernet Full Duplex Configuration screen, Figure 5-19, allows theuser to set ports 1 through 24, individually or all at once, to eitherStandard Ethernet or Full Duplex operation, and monitor each port to seewhether or not it is enabled and linked to another 10BASE-F device.Refer to Section 5.15 to set the Operation Mode for ports 25 and 26.To access the Ethernet Full Duplex Configuration screen from the DeviceConfiguration Menu screen, use the arrow keys to highlight theETHERNET FULL DUPLEX CONFIGURATION menu item andpress ENTER. The Ethernet Full Duplex Configuration screen displays.Figure 5-19 Ethernet Full Duplex Configuration ScreenThis section explains each field of the Full Duplex Configuration screen.PORT # (Read-only)Identifies the number of the port.Firmware Revision: XX.XX.XXEthernet Full Duplex Configuration23141-21Device Type: 2E48-27RBOOTPROM Revision: XX.XX.XXPORT #123456789101112LINK STATUSLinkLinkLinkNo LinkLinkLinkLinkLinkLinkLinkLinkLink2E48-27R LOCAL MANAGEMENTEvent Message LineSAVEOPERATION MODE[STANDARD ENET][STANDARD ENET][STANDARD ENET][STANDARD ENET][STANDARD ENET][STANDARD ENET][STANDARD ENET][STANDARD ENET][STANDARD ENET][STANDARD ENET][STANDARD ENET][STANDARD ENET]PORT STATUSENABLEDENABLEDENABLEDENABLEDENABLEDENABLEDENABLEDENABLEDENABLEDENABLEDENABLEDENABLEDSET ALL PORTS: [FULL]RETURNRETURN[13-24]EXIT
