General Configuration Screen2E48-27R/2E49-27R User’s Guide5-235.7.3 Setting the Default GatewayIf the SNMP management station is located on a different IP subnet thanthe 2E4X-27R, a default gateway must be specified. When an SNMP Trapis generated, the 2E4X-27R sends the Trap to the default gateway. To setthe default gateway, perform the following steps:1. Use the arrow keys to highlight the Default Gateway field.2. Enter the IP address of the default gateway using the DDN format.For example: 134.141.79.1213. Press ENTER. If the default gateway entered is a valid format, thecursor returns to the beginning of the Default Gateway field. If theentry is not valid, the screen displays “INVALID DEFAULTGATEWAY OR FORMAT ENTERED”. Local Management does notalter the current value, but it does refresh the Default Gateway fieldwith the previous value.4. Use the arrow keys to highlight the SAVE command.5. Press ENTER. The message “SAVED OK” displays at the top of thescreen.5.7.4 Setting the TFTP Gateway IP AddressIf the network TFTP server is located on a different IP subnet than the2E4X-27R, a Gateway IP address should be specified. To set the TFTPGateway IP address, perform the following steps:1. Use the arrow keys to highlight the TFTP Gateway IP Addr field.2. Enter the IP address of the TFTP gateway using the DDN format.For example: 134.141.80.1223. Press ENTER. If the TFTP gateway IP address entered is a validformat, the cursor returns to the beginning of the TFTP Gateway IPAddress field. If the entry is not valid, the screen displays “INVALIDTFTP GATEWAY IP ADDRESS OR FORMAT ENTERED”. LocalManagement does not alter the current value, but it does refresh theTFTP Gateway IP Address field with the previous value.4. Use the arrow keys to highlight the SAVE command, then pressENTER. The warning screen shown in Figure 5-12 displays.
