Chapter 5: Local Management5-442E48-27R/2E49-27R User’s Guide[1-12] or [13-24] (Navigation Key)When the Full Duplex Configuration screen displays, the currentoperation mode and status information are displayed for the first 12 ports.This field allows the user to step to the second screen for the same type ofinformation for ports 13 through 24. While on the second screen, the usercan navigate back to the first screen by highlighting the [1-12] field andpressing ENTER. The user can change the Operation Mode fields while ineither the first or second screen.5.11.1 Setting the Operation ModeThe Operation Mode may be set to Standard Ethernet or Full Duplexeither one port at a time or all at once. The following steps describesetting the port Operation Mode for individual ports followed by steps toset the Operation Mode for all ports.To set the Operation Mode for individual ports, proceed as follows:1. Use the arrow keys to highlight the OPERATION MODE fieldadjacent to the number of the port(s) that you plan to change.2. Press the SPACE bar until the appropriate mode, FULL DUPLEX orSTANDARD ENET displays in the field.3. Use the arrow keys to highlight the SAVE command.4. Press ENTER. The message “SAVED OK” displays.To set all Ethernet ports (1 through 24) for Full Duplex or StandardEthernet operation, proceed as follows:1. Use the arrow keys to highlight the SET ALL PORTS field.2. Press the SPACE bar until you see FULL or STANDARD.3. Use the arrow keys to highlight the SAVE command.4. Press ENTER. The message “SAVED OK” displays.NOTEThe Operation Mode for the first 12 ports can be changed onthe first screen. To display the Operation Mode for Ports 13through 24, use the arrow keys to highlight the Ports [13-24]field and press ENTER. To again display the Operation Modefor Ports 1 through 12, use the arrow keys to highlight the Ports[1-12] field and press ENTER.
