CSX400 Configuration with QuickSET108 CSX400 and CSX400-DC User’s GuideIP Routing ConfigurationThis section describes the fields in the IP Routing Configuration section of the Routingconfiguration window.Interface # — Displays an interface number assigned an IP subnet.Remote LAN Subnet — Displays the IP subnet assigned to the interface number.Subnet Mask — Displays the Subnet Mask assigned to the interface number.Next Hop — The Next Hop is the IP address of the IP port of the next router (in the direction ofthe subnet that you are defining).Default Route... — Displays the Default Route window. You can select one interface to be adefault route. A default route forwards all packets that are not defined in the routing table to theinterface defined in the Default Route window (Unnumbered Routing Only). To set up a defaultroute in “Numbered Mode” communication, click the Add Route button and enter IP Subnet000.000.000.000, and Subnet Mask 255.255.255.255. Then use the NEXT HOP window to enterthe IP Address of the router you wish to designate as the default route.Add Route... — This button allows you to add a route and to configure the CSX400 to forwardonly those packets from the specified route.Delete — This button allows you to delete a routeAdvanced — This button allows you to access the Advanced Routing configuration window.IPX Routing ConfigurationThis section describes the fields in the IPX Routing Configuration section of the (IP/IPX) Routingconfiguration window that is used to assign an IPX network number.Interface # — Displays all interface numbers which can be assigned an IPX network number.Network # — Displays the active IPX network number assigned to an interface.Host Map... — The IPX Host Map button takes you to the IPX Host Map window. IPX Host Mapentries are used for IPX routing in Frame Relay mode only.Modify... — Use this button to change an entry in the IPX Routing Configuration window. Selectthe interface number to modify by clicking on the tab to the left of the interface number.
