Cabletron Systems Cabletron CyberSWITCH CSX400 User Manual

Also see for CyberSWITCH CSX400: Setup guide Configuration guide User guide User guide User guide

Contents

EPIM SpecificationsCSX400 and CSX400-DC User’s Guide 221EPIM-CThe EPIM-C supports thin coaxial cabling and is equipped with an internal Cabletron SystemsTMS-3 Transceiver. You can use the TERM switch on the front of the EPIM-C to set the internal50-ohm terminator. This eliminates the need to connect the port to a T-connector and terminator.Figure 81 shows the setting for the terminator switch.Figure 81 EPIM-CConnector TypeThis connector type is a BNC receptacle with gold center contact for use with BNC typeT-connectors and RG58 coaxial cable.GroundingThe BNC port of the Coaxial Interface Modules is not connected to earth ground.!CAUTIONFor safety reasons, only one end of a coaxial segment should be connected to earthground. Connection to earth ground at more than one point on the segment maycause dangerous ground currents.Internal Termination Switch= On (internally terminated)= Off (need external termination)