Cabletron Systems SMALL OFFICE CyberSwitch 150 Manual

Also see for SMALL OFFICE CyberSwitch 150: Quick start guide User guide

EXAMPLE NETWORKS100 CyberSWITCH• AppleTalk network range:This range specifies the AppleTalk network range of the LAN segment that the port isconnected to. As indicated by the topology worksheet, the network range for SITE1’s LAN is10-13.Note: If we wanted SITE1 to be in discovery mode, we could have entered a range of 0-0. Inthe discovery mode, the system is a non-seed router, learning about its network froma seed router. Each network must have at least one seed router. Entering a networkrange for SITE1’s LAN port designates SITE1 as a seed router.• suggested AppleTalk addressWe want to select the default (none). This means that an unused AppleTalk address willtransparently be assigned to the LAN port. If desired, you can suggest an AppleTalk addressyou would like to use for the port. When an address is suggested, that address will be used if,after a probe is done, it is known that no other device is using that address.• default zone nameBy assigning multiple zone names, you can logically group nodes on an internet. Each namecan be configured to represent a logical group within that respective internet. As indicated onthe topology worksheet, SITE1 uses two zones: Engineering and Marketing.Enter SITE1.Engineering as the default zone name, then press 1 to add SITE1.Marketing as thesecond zone. The following screen will then be displayed:Note: No zone configuration menu is presented for ports in discovery mode.The LAN AppleTalk port information is now complete. To configure the WAN UnNumbered portsimply press 1 to add a port, then select the WAN UnNumbered port type.Normally, at this point, we would configure the necessary static routes. But, we can not configurea static route until we configure device SITE2. This is because a static route using an UnNumberedport requires a device name for the route’s next hop device. You can not enter a device name of adevice that has not been configured. Device information is configured under the Security Menu.Return to the main CFGEDIT menu.Current Zones for PORT "lanport1":Id Zone name-- --------------------------------1 Site1.Engineering (default)2 Site1.Marketing(1) Add, (2) Change, (3) Delete a Zoneor for previous menu ?