Cabletron Systems SMALL OFFICE CyberSwitch 150 Manual

Also see for SMALL OFFICE CyberSwitch 150: Quick start guide User guide

EXAMPLE NETWORKS56 CyberSWITCHNo other changes are required. Return to the Device Table Menu.Next, we will configure the Bridge Ethernet Address and Password. At the Device Table Menupress 4, Authentication. The following screen is displayed:Press 6 to specify Bridge Ethernet Address (123123123123); and press 7 to specify Bridge Password(q3bay) at this prompt.Return to the Device Table Menu and select 5, IP Routing. Disable IP routing for this device.We will configure bridging options next. Return to the Device Table Menu and press 8, Bridging:• Select IP (Sub-)Network Number. Respond to the prompt as follows:• Select Bridging. Enable bridging.• Leave remaining options disabled. (The Make Calls... feature is not supported for RLANinterfaces; the IPX... options are not applicable for this example.)Return to the On-node Device Entries Menu. Configuration is now complete for the deviceMonterey. Enter the device Carmel in the same way, providing its Bridge Ethernet address andpassword.C ONFIGURING THE U SER L EVEL D ATABASESThis network doesn’t require the use of a user level database. Therefore, no changes are necessary.Device ISDN Line Protocol Menu: (Device = "Monterey")1) PPP (Point to Point Protocol)2) HDLC Bridge3) IP Host (RFC1294)Select option to associate with device "Monterey",or “0” to disable ISDN access for this device [default = 1]? 2Device Authentication Menu: (Device = "Monterey")PPP:1) PAP Password ""2) CHAP Secret ""3) Outbound Authentication ENABLED4) User Level Authentication DISABLEDIP Host (RFC 1294):5) IP Host Id ""HDLC Bridge:6) Bridge Ethernet Address ""7) Bridge Password ""ISDN:8) Calling Line Id(s) ""Select function from above or for previous menu: 5IP (Sub-) Network Number in dotted decimal notation or NONE [default = NONE]?198.12.10.0