Cabletron Systems SMALL OFFICE CyberSwitch 150 Manual

Also see for SMALL OFFICE CyberSwitch 150: Quick start guide User guide

EXAMPLE NETWORKS68 CyberSWITCHAfter you save the LAN interface configuration, press 1 to add the next interface. Configure theinformation for the WAN (UnNumbered) interface as follows:As the above screen shows, not much information is needed to configure a WAN (UnNumbered)interface. Simply press 5 to select the WAN (UnNumbered) interface type, then press toaccept the default of 1500 as the MTU size.After you save the interface information, a screen summarizing the configured interfaces will bedisplayed.Normally, at this point, we would configure the necessary static routes. But, because this exampleuses an UnNumbered Interface, we must first configure the device that will act as SITE1’s next hop.We must do this because to add the static route for an UnNumbered interface, you need to enterSITE2’s device name for the next hop device. To do this, you must already have configured deviceSITE2.Return to the Main Menu to begin the device configuration.A DDING D EVICE SITE2Begin by pressing 3 at the Main CFGEDIT Menu. The Security Menu will then be displayed. Then,press 1 at the Security Menu, and the Security Level Menu will be displayed. To enable DeviceLevel Security, press 2.Press 3 at the Security Menu, and the Device Level Database Menu will be displayed. To enable theOn-node Device Database, press 1 and follow the on-screen instructions.To add the remote devices, press 2 (On-node Device entries). Press 1 to add the device. You will firstbe asked to enter the Device Name as shown below:After the new device name has been specified, the following screen is displayed.1) LAN2) WAN3) WAN (Direct Host)4) WAN (RLAN)5) WAN (UnNumbered)Select function from above or for previous menu: 5Enter the MTU size in bytes [default = 1500]? Device Name? SITE2