Cabletron Systems SMALL OFFICE CyberSwitch 150 Manual

Also see for SMALL OFFICE CyberSwitch 150: Quick start guide User guide

Small Office Remote Access Switch 89IPX ROUTING N ETWORKConfigure IPX Routing: Masternet (Detroit)You will then be asked for the IPX external network number for the LAN interface. Enter 0100.For the rest of the prompts, press to accept the default values (including the default valuesfor the LAN RIP information).Add a Remote LAN InterfaceAfter completing the LAN interface configuration, select Add to add the next interface for theRemote LAN. Configure the information for the WAN (Remote LAN) interface as follows:Note that the IPX Network Number in the above screen refers to the external network number of theRemote LAN (i.e., the bridged sites).The following menus will be presented if the IPX RIP/SAP protocols are enabled for the system.For Remote LANs, the remote peer (bridge) is not expected to understand RIP/SAP protocols. Inthe event that the remote peer does understand these protocols, we suggest the followingconfiguration: do not send, receive, and respond. This will allow the remote peer to see NetWareservices when the remote bridge is connected. When not connected, the services will age-out andeventually go away.The RIP/SAP menus will appear similar to the following:1) LAN2) WAN (Remote LAN)Select function from above or for previous menu:2INTERFACE NAME or to cancel ?remotelanEnter the hexadecimal IPX Network Number or to cancel ?0128Enter the packet encapsulation type1) Ethernet_II2) Ethernet_802.23) Ethernet_802.34) Ethernet_SNAP[default = ETHERNET_802.2] ?2Enter the MTU size in bytes [default = 1497]? RIP Send Control:1) Do Not Send.2) Send.Enter a RIP Send Control from the above menu [default = 2]? 1RIP Receive Control:1) Do Not Receive.2) Send.Enter a RIP Receive Control from the above menu [default = 2]? 2RIP Respond Control:1) Do Not Respond.2) Send.Enter a RIP Respond Control from the above menu [default = 2]? 2