Cabletron Systems SMALL OFFICE CyberSwitch 150 Manual

Also see for SMALL OFFICE CyberSwitch 150: Quick start guide User guide

EXAMPLE NETWORKS98 CyberSWITCHC ONFIGURE THE C YBER SWITCHNote: The software should have already been installed and you need the system prompt beforeproceeding with these steps.Using the detailed instructions for these steps found in the Simple Remote Bridging chapter,complete the following configuration steps for SITE1.Start the CFGEDIT programSelect physical resourcesSelect to add a resourceSelect Switch type to be NI-1Select to add a lineEnter the line nameSelect slot and port numbersSelect line interface type of “Point-to-Point”Add Data Links (Data Link explanation follows)Choose Auto TEI NegotiationEnter Service Profile ID (SPID) ValueEnter Directory Number for Data LinkEnter Maximum Number of Digits to VerifyRepeat “Add Data Links” for second Data LinkRepeat “Select to add a line” for each additional lineData links are handled differently on a NI-1 switch. Some BRI lines have only one phone number(for the Data Link), but can handle two calls (one for each bearer channel). For NI-1 switches, theBRI line has two phone numbers (one for each bearer channel), and each phone number has its ownSPID. You must enter the number of digits to verify, so that when the system receives a phone callit can determine on which bearer to accept the phone call. Refer to the System Details worksheet forthe SPIDs, directory numbers, and the number of digits to verify.The sections below provide instructions for completing the remaining configuration steps forSITE1.CONFIGURING THE O PTIONSBy default, AppleTalk Routing is disabled. Before we can begin configuring the AppleTalk feature,we must first enable AppleTalk Routing. From the Options Menu, select AppleTalk Routing (Enable/Disable). Follow the onscreen instructions to enable AppleTalk Routing. The following expandedscreen will then be displayed:We will use this menu to configure SITE1’s AppleTalk information.AppleTalk Routing Menu:1) AppleTalk Routing (Enable/Disable)2) AppleTalk Ports3) AppleTalk Static Routes4) Isolated Mode (Enable/Disable)Select function from above or for previous menu: