Cabletron Systems SMALL OFFICE CyberSwitch 150 Manual

Also see for SMALL OFFICE CyberSwitch 150: Quick start guide User guide

EXAMPLE NETWORKS92 CyberSWITCHS AVE C ONFIGURATION F ILESWe have now configured all the required information for masternet, the IPX router in Detroit.Return to the Main Menu, save your configuration files, and exit. Restart the IPX router to activatethe changes.C ONFIGURE THE R EMOTE D EVICESConfigure the remote devices in a similar manner as the masternet configuration:• Keep in mind that the Tampa and Orlando sites are bridges. Be sure to enable bridging, andconfigure each one to dial-in to masternet.• Configure the Dallas site as an IPX router. Verify that it supports Triggered RIP/SAP. Enableand configure IPX routing, and add masternet as dallasnet’s device.V ERIFY THE INSTALLATIONSteps on how to verify the installation are detailed in the System Verification chapter of the User’sGuide. This section gives an outline of which steps should be executed.On each system:Verify resources are operationalIssuedr commandLook for WAN board initialized messagesLook for BRI line messagesLook for LAN initialization messagesLook for Bridge initialization messagesVerify WAN Lines AvailableConnect WAN linesIssuedr commandLook for “Data Link up 1,1” in reportsOnce call connectivity is verified, verify the routing configurations:On masternet IPX router:Issue IPX service command to display its SAP table.Has the CyberSWITCH learned about local servers?Can it ping them (IPX ping internal network # )?Has it learned about servers in Dallas?Issue IPX route command.Has masternet learned a route to Dallas network?Can masternet ping a server on the Dallas network?Can clients in Dallas automatically generate a call and login successfully to serverin Detroit?Can clients in Detroit automatically generate a call and login successfully to serv-ers in Dallas?Can remote bridges at Tampa and Orlando dial-in to masternet?Can clients on their LANs attach and login to servers on masternet?Do their attempts to login to masternet automatically generate a call?