Personalization FeaturesThe following choices are available for programming:Personalization NameThis feature allows you to type in a name that willappear on the DIC display whenever the correspondingRemote Keyless Entry (RKE) transmitter is used orone of the buttons on the driver’s door armrest (1 or 2)is pressed.If a customized name is not programmed, the systemwill show DRIVER 1 or DRIVER 2 to correspond with thenumbers on the back of the RKE transmitters.To program a name, use the following procedure:1. Enter the Personalization menu following theinstructions listed previously.2. Select the PERSONALIZATION NAME menu itemby pressing the TUNE/SEL knob once.You will see a cursor on the screen.3. Turn the TUNE/SEL knob until you reach the firstletter you want. The letter will be highlighted. Thereis a complete alphabet with both upper and lowercase letters and the numbers zero throughnine. Also included are spaces and other non-lettercharacters such as the ampersand (&).4. Press the TUNE/SEL knob once to select the letter.The letter will then appear on the display.If you make a mistake, press the CLR button.This will exit the menu. You can then go back intothe menu and edit the name. You can alsopress the TUNE/SEL knob repeatedly to cyclethrough all the characters until you reach thecharacter you wish to change.5. Repeat Steps 3 and 4 until the name you want iscomplete. You can program up to 16 characters.The name you selected is now set. You can either exitthe programming mode by following the instructionslater in this section or program the next feature availableon your vehicle. To program the next feature, enterthe personalization portion of the SETUP menu followingthe instructions listed previously.Configure Display KeysThis feature allows you to customize the functions of thefour soft keys located to the left and right of the audiodisplay. See “Configurable Radio Display Keys”under Radio with CD on page 3-85 for programminginformation.3-71