Reprogramming a Single UniversalHome Remote ButtonTo program a device to Universal Home Remote usinga Universal Home Remote button previously trained,follow these steps:1. Press and hold the desired Universal HomeRemote button. Do not release the button.2. The indicator light will begin to flash after20 seconds. While still holding the Universal HomeRemote button, proceed with Step 2 under“Programming Universal Home Remote” shownearlier in this section.For additional information on Universal Home Remote,see Customer Assistance Offices on page 7-4.Storage AreasGlove BoxTo open the glove box, lift up on the lever. The glovebox has a light inside. Use the key to lock and unlock.Cupholder(s)There are cupholders located in the full floor console, orin the front of the center seat console. In addition tothis, cup holders are located in the rear armrest.To access the full floor console cupholder slide thecover back. To access the center seat consolecupholder, turn the front portion of console.Coinholder(s)Your vehicle may be equipped with a coinholder.Center Console Storage AreaIf your vehicle has a full floor console it has two storageareas. To access the upper tray storage, lift the leftlever located in the front of the armrest lid. To accessthe lower storage area, lift the right lever. If your vehiclehas a center seat console it will have two storageareas. To access the upper storage area, press thebutton located on the front of the armrest and liftthe armrest lid. To access the lower storage area, pullthe strap located behind the cup holder.2-49
