Black plate (5,1)Cadillac CTS/CTS-V Owner Manual (GMNA-Localizing-U.S./Canada/Mexico-6014443) - 2014 - CRC - 4/3/13In Brief 1-5Press and hold L forthree seconds to sound the panicalarm.Press L again to cancel the panicalarm.For Keyless Access vehicles, pressthe button to remove the key. Thekey can be used for all locks.See Keys on page 2-2 and RemoteKeyless Entry (RKE) SystemOperation (Keyless Access) onpage 2-4 or Remote Keyless Entry(RKE) System Operation (KeyAccess) on page 2-9.Remote Vehicle StartIf equipped with this feature, theengine can be started from outsideof the vehicle.Starting the Vehicle1. Aim the transmitter at the vehicleand press and release Q on thetransmitter.2. Immediately after completingStep 1, press and hold / for atleast four seconds or until theturn signal lamps flash.3. After entering the vehicle duringa remote start, press the brakepedal and turn the ignition toON/RUN to drive the vehicle.When the vehicle starts, the parkinglamps will turn on and remain on aslong as the engine is running. Thedoors will be locked and the climatecontrol system may come on.The engine will continue to run for10 minutes. Repeat the steps for a10-minute time extension. Remotestart can be extended only once.Canceling a Remote StartTo cancel a remote start do any ofthe following:. Aim the RKE transmitter at thevehicle and press and hold /until the parking lamps turn off.. Turn on the hazard warningflashers.. Turn the vehicle on and then off.See Remote Vehicle Start onpage 2-11.Door LocksTo lock or unlock a door manuallyuse the door lock knob on top of thedoors.Wagon/Sedan ModelFrom inside, pull a front door handleto unlock. Pulling the door handleagain unlatches the door. For a reardoor use the door lock knob on thetop of the door.From the outside, turn the keytoward the front or rear of thevehicle, or press Q or K on theRemote Keyless Entry(RKE) transmitter.