Tip!: Carefully choose the area to place the machine!Note when you place the machine near other electrical appliances suchas fluorescent lampsPlace the machine at least 5.91 inches / 15 cm away from other electrical appliances such asfluorescent lamps. If the machine is placed closer to those, it may not be able to work properlydue to fluorescent noises.Note when you use the machine on wireless LANSince the microwave oven and the wireless LAN system use the same frequency bandwidth, themicrowave oven can be the potential source of interference when the microwave oven is on.Placing this machine close to microwave oven may result in the poor status of radio.How to maintain the optimal printing quality?The key to printing with the optimal printing quality is to prevent the Print Head from drying or clogging.Always follow the following steps for optimal printing quality.Follow the procedure below to disconnect the power plug.1. Press the ON button on the machine to turn it off.2. Make sure that all lamps on the Operation Panel are not lit.3. Disconnect the power plug from the wall outlet.If you press the ON button to turn off the power, the machine caps the Print Head (nozzles)automatically to prevent from drying. If you disconnect the power plug from the wall outlet beforeall lamps on the Operation Panel are turned off, the Print Head will not be capped properly andthis will cause drying or clogging.To disconnect the power plug, be sure to follow this procedure.ImportantIf the power plug is disconnected, the date/time settings will be reset and all documentsstored in memory will be lost. Send or print a necessary document, or save it on a memorycard or USB flash drive before disconnecting the power plug.Print periodically!Just as the tip of a felt pen becomes dry and unusable if it has not been used for a long time,even if it is capped, the Print Head too, may become dried or clogged if the machine has notbeen used for a long time.We recommend you to use the machine at least once a month.NoteDepending on the type of paper, ink may blur if you trace the printed area with a highlight pen orpaint-stick, or bleed if water or sweat comes in contact with the printed area.Page 149 of 1086 pagesTips on How to Use Your Machine
