Advanced Guide > Faxing > Sending/Receiving Faxes Using the Operation Panel of the Machine > Using Speed DialUtility > Starting Up Speed Dial UtilityStarting Up Speed Dial UtilityBefore starting up Speed Dial Utility, confirm the following:The necessary application software (MP Drivers and Speed Dial Utility)is installed.If the application software (MP Drivers and Speed Dial Utility) is not yet installed, insert the Setup CD-ROM into the computer's disc drive, then perform Custom Install and select MP Drivers andSpeed Dial Utility.The machine is connected to a computer correctly.Make sure that the machine is connected to the computer correctly.Do not plug in or unplug the USB or LAN cable when saving registered information on the computer,or when the computer is in sleep or standby mode.If you use Speed Dial Utility via a network connection, make sure that all the required settings havebeen specified.1. Make sure that the machine is turned on.2. Click Start and select All programs (or Programs), Canon Utilities, Speed Dial Utility,and then Speed Dial Utility.Speed Dial Utility starts up.Page topPage 777 of 1086 pagesStarting Up Speed Dial Utility
