Common Functions 1-331 Before You Start Using the MachineQuiet ModeIf the machine is not used for about 15 seconds after the last print job or other task has finished, themachine enters quite mode and all internal mechanical noise stops.NOTE• The time that elapses until the machine enters quiet mode can be set in the range of 15 to 60 seconds.Auto Drawer SwitchingIf the selected paper drawer runs out of paper, the machine will automatically switch to anotherpaper drawer loaded with the same size paper, if available.NOTE• You can set a paper drawer to Auto Drawer Switching for each individual copy and printer function. Youcan also set the Auto function to stop feeding when the paper type, rather than the size, is changed. (See“Setting a Paper Drawer to Auto Drawer Switching,” in the Reference Guide.)Auto Rotate FunctionIf the image size calculated from the original size at the specified copy ratio does not fit on the papersize unless it is rotated, the machine will automatically rotate the orientation of the image for print-ing. For example, if an LTR-size (Horizontal) original is copying, the machine will automaticallyrotate the image so that it can be printed on an LTR (Vertical) page.NOTE• If the image does not fit on the paper even after rotation, the machine will not rotate the image but will printit as is, with part of the image cut off.• Rotation is not applied when the ratios are set independently for the X and Y axes (XY Zoom). Also, rota-tion is not applied in some cases when using Image Separation. (See “Enlarging/Reducing Originals atCopy Ratios Set Independently for the X and Y Axes,” on p. 2-47, or “Dividing an Original into Equal Sec-tions and Enlarging Each Section on a Separate Copy Sheet,” on p. 3-31.)Auto Clear FunctionAfter printing, if the machine is not in operation for a period of about two minutes, it automaticallyreturns to the standard settings.NOTE• You can set the Auto Clear time from one to nine minutes, in 1-minute increments. You can also cancelthis function. (See “Setting the Time Taken for the Display to Return to the Basic Features Screen AfterCompleting Operations,” in the Reference Guide.)
