Canon LBP351 Series Service Manual

Also see for LBP351 Series: User guide Getting started

Contents

Item DescriptionUSB-H To set to enable/disable the USB host function.By turning ON the host function, USB flash drive can be used.CAUTION:Points to note when pulling out the USB flash drive• Be sure to pull out the USB flash drive after turning USB-H to OFF because theUSB flash drive is in the connected state when USB-H is ON.• Pulling out the USB flash drive while it is being accessed causes an error.ON: Use the USB host function.OFF: Do not use the USB host function. (* default)SUBLOG TO USB To output sublog to the USB flash drive.It can be used regardless of the USB-H setting.CAUTION:It cannot be executed more than 2 times consecutively.Since automatic recording of sublog can no longer be performed when executedonce, be sure to turn OFF and then ON the main power after execution.SHIPLOCK Not useMEAPMEAP-PN To specify the port number of MEAP HTTP.• 1 to 65535 (8000 *default)MEAP-SSL To specify the port number of MEAP HTTPS.• 1 to 65535 (8443 *default)CDS-MEAP To set whether to permit the user administrator to install MEAP application.• On*/OffCDS-FIRM To set whether to permit the user administrator to update firmware.• On/Off*CDS-UGW To set whether to permit firmware update from UGW.• On/Off*CDS-LVUP To set whether to permit service technician or user administrator to use the periodical updatefunction of CDS.• On/Off*CDS-CTL It is a menu to switch countries for obtaining firmware via CDS.Use this item to switch countries when obtaining firmware from another country due to the dis-tance to the location server.MEAP FUNCTION Use this item when "E602-0009" occurs. It is a menu to clear the error code and recover MEAP.• ON: Recover MEAP. (default)• OFF: Do not recover MEAP.LCDSFLG To set whether to allow the user administrator to use the CDS in local environment (L-CDS).• On/Off*CLEAR MEAP To delete the following data retained by MEAP application at the next startup.• MEAP application• Data retained by MEAP application• Data retained by the service-purposed area in the MEAP platformCLEAR CDS To delete the CDS-related settings at the next startup.DDNSINTY To change DDNS periodical update interval• 0: Do not perform periodical update.• 1 to 48: 1 to 48 hours (default value: 24)NOTE:[Description of terminology]DDNS (Dynamic Domain Name System): A system to dynamically register and managethe IP addresses which are dynamically allocated and their host names9. Service Mode171