[Enlarge/Reduce toFit Paper Size]If the check box is selected, it fixes the aspect ratio and scales it to fit with the effective printarea of the paper size that is set and prints. However if [Paper Size] is set as [Auto], this itemcannot be set.[Enlarge Print Area]Specify whether to expand the printable area and print.Depending on the document to be printed, part of the edges of the paper may not beprinted.[Print 2-Sided] Specify 1-sided or 2-sided printing.[Binding Location]Set the binding position on the long side of the paper (long-edged binding) or the short side ofthe paper (short-edged binding). If binding is set from the printer side, the position of the"gutter" is automatically adjusted on the front and back sides of the paper.[N on 1] You can print multiple pages of the XPS file data arranged on one page.When printing multiple pages side by side, set [Paper Size] to a setting other than [Auto].[Page Order] The [N on 1] setting enables you to set the order the pages will be arranged on the paperwhen printing multiple pages on one page.[Finishing](It is only displayed when an SD card is used.)It collates and prints in page or section units.[Off]: Print the number of copies specified for every page.[Collate]: The specified number of copies are collated.[Store in Box](It is only displayed when an SD card is used.)When storing it in a box, check the [Store in Box] check box before selecting the box whereyou want to store it.9Click [Start Printing].Do not keep clicking [Start Printing] while the file is transferring. Sometimes it takes time to transfer a file, but if youkeep clicking during the transfer, a file failure may occur and it may be impossible to transfer it. When the print job has finished sending, the display switches and the following message is displayed.Press [To Job List] to check the print job that was sent.㻞㻥㻜㻌㻛㻌㻥㻢㻟Downloaded from ManualsPrinter.com ManualsDownloaded from www.Manualslib.com manuals search engine
