Model 190 Installation, Technical and Operation8400-M022-O1 Rev J Page 14514.4 Auto Axle Weighing Operation1. In the idle state the light will be green and the system will wait for atruck to approach2. The first axle is driven on the scale and the weight exceeds tHrS, thethreshold weight. The traffic light will turn red. The Gross weight forthat axle will be displayed.3. After the motion on the scale stops, the printer will print the weight onthe scale and add the weight to the total accumulator. The Printdmessage will be displayed on the 190 display.4. After the SDLY (Stoplight Delay) timer runs out the light will turn green.At this time the system is ready for the next axle, if any.5. Repeat steps 2 through 5 for each new axle.6. After all of the axles have been weighed and the scale weight is belowtHrS (threshold weight), the TdLY (Total Delay) time expires the totalweight will be printed and displayed on the 190 display.14.4.1 Auto Axle Weighing Ticket FormatDATE TIME1 WWWWWW lb2 WWWWWW lb# WWWWWW lbTotal: WWWWWW lbWhere W is the weight, lb are the units.Once all axles have been weighed and the TdLY (Total Delay) timer runsout (ticket printed), the application is reset and is ready for the next truck.
