Model 190 Installation, Technical and Operation8400-M022-O1 Rev J Page 155Prty= (Option Card Parity Setting)Press the TARE key to show the current setting. If the setting displayedis 0, press the TARE key again to save it. Otherwise, use the Fn/ keyto toggle the parity setting to 0 (No Parity with 8 data bits) and then pressthe TARE key to save it.NOTE: The default parity is 0 (No Parity with 8 data bits) and should notbe changed.Cont2= (Continuous Output on Option Card)Press the TARE key to show the current setting. If the settingdisplayed is no (no), press the TARE key again to save it. Otherwise,use the Fn/ key to toggle the setting to no (No Continuous Output onOption Card) and then press the TARE key to save it.NOTE: The default continuous output is no (No Continuous Output onOption Card) and should not be changed.16.4 Ethernet Cable InstallationConnections to the 190 are by CAT 5 or equivalent cable. Consult yournetwork administrator for the proper procedure to terminate the cable.After the cable has been terminated, plug the cable into the Ethernet porton the 190-IP.16.5 IP Address SetupBefore operation may begin the Ethernet Device Server must have an IPAddress. To facilitate control over the indicator on a network, we haveincluded the DeviceInstaller by Lantronix.See the DeviceInstaller Users Guide (DeviceInstaller_UG.pdf) in theLantronix DeviceInstaller folder on the Model 190 Installation, Technicaland Operation Manual CD (8400-M022-O1) for details.16.6 190-IP OperationA client TCP connection to the 190-IP IP address at its listening port,10001, can be used to send commands to the 190 indicator. A descriptionof the available commands are describe in section 9.11 ASCII Commands.
