Model 190 Installation, Technical and Operation8400-M022-O1 Rev J Page 897. INDICATOR SETUP REVIEWThe 190 indicator allows several operational parameters to be reviewedand changed without breaking the calibration seal.7.1 Accessing Setup Review1. With the indicator ON, press Fn/ key and then the ZERO key.2. The display will change to show td= (the prompt for selection of a12 or 24 hour clock).3. Press the TARE key to show the current setting. If the settingdisplayed is acceptable, press the TARE key again to save it.Otherwise, use the Fn/ key to toggle to a new setting and thenpress the TARE key to save it and advance to the next prompt.4. To exit Setup Review, press the TARE key to step through theremaining prompts OR at any time, cycle the power (press theON/OFF key twice).Td= Time and Date (Select 12 or 24 hour clock)d in= Digital Input (Disable or Select key function)d out= Digital Output (Disable or Select Preset/Checkweigherfunction)SLEEP= Sleep Mode (Disable or Select number of minutesbefore entering sleep mode)A off= Auto Shutoff (Disable or Select number of minutesbefore automatic shutoff)toUCH= Key Touch Sensitivity (Select number of millisecondskey must be touched before key press is acted upon)Sio? Serial Input/Output Configuration(Select YES or NO)baUd= Select Serial Port Baud Rateprty= Select Serial Port ParityCont1= Enable or Disable Continuous Output to the Serial Porttype= If Cont1=YES(Select Continuous Output Format, SMA or CardinalScoreboard)
