1 - 316Chapter 1 TroubleshootingVersion 2 2008.03.31FIP-1. 73 Paper Jam 077-901Step Check RemedyYes NoPossible causative parts:CLUTCH ASSY DRV (PL3.1.1)ACTUATOR REGI ROLL (PL3.2.8)ROLL ASSY REGI (PL3.2.9)ROLL REGI METAL (PL3.2.10)ACTUATOR REGI IN (PL3.2.11)SENSOR PHOTO (PL3.2.13)TRANSFER ASSY (PL6.1.7)DRIVE ASSY MAIN (PL7.1.2)HARN ASSY L SIDE (PL10.4.18)PWBA MCU (PL10.7.7)HARN ASSY MAIN MOT (PL10.8.7)HARN ASSY KSNR REGCL (PL10.8.9)1 Checking the paper sizeDoes the using paper size meet the specification? Go to step 3.Use the paper thatmeets thespecifications,then go to step 2.2 Does the error still occur when printing? Go to step 3. End of work.3 Checking the paper conditionIs the paper wrinkled or damaged?Replace the paperwith a new and dryone, then go tostep 4.Go to step 5.4 Does the error still occur when printing? Go to step 6. End of work.5Checking after reloading a new paperReload a new paper.Does the error still occur when printing?Go to step 6. End of work.6Checking the COVER ASSY FRONT for latchingOpen and close the COVER ASSY FRONT, and then latchcorrectly.Does the error still occur when printing?Go to step 7. End of work.7Checking around the Regi SensorAre there any remaining paper and/or foreign substancearound the Regi Sensor?Remove the paperand/or substance,then go to step 8.Go to step 9.8 Does the error still occur when printing? Go to step 9. End of work.9Checking the TRANSFER ASSYAre there any remaining paper and/or damage on the belt ofthe TRANSFER ASSY?Remove theremaining paper. Ifthe belt isdamaged, replacethe TRANSFERASSY. (Refer toRemoval 48/Replacement 12.)Go to step 10.10Checking the ROLL ASSY REGI and ROLL REGI METALfor shape and operationRemove the PHD UNIT once to check the followings.Are ROLL ASSY REGI and ROLL REGI METAL seatedcorrectly?Also, are they not contaminated and/or damaged, androtated smoothly?Check these items by turning with your finger.Go to step 11.Clean or replacethe defectiveROLL(s).
