1 - 420Chapter 1 TroubleshootingVersion 1 2008.02.01FIP-1.N3 During PrintingStep Check RemedyYes NoPossible causative parts:SEPARATOR ROLLER ASSEMBLY (PL2.1.5)ROLL ASSY FEED (PL3.2.4)ROLL ASSY REGI (PL3.2.9)ROLL REGI METAL (PL3.2.10)PHD UNIT (PL4.1.21)FUSER ASSY (PL6.1.1)TRANSFER ASSY (PL6.1.7)DRIVE ASSY SUB (PL7.1.1)DRIVE ASSY MAIN (PL7.1.2)FAN (PL10.6.17)1Checking the paper feedingDoes the noise arise from the printer when the paper is fedfrom the Tray 1?Go to step 2. Go to step 6.2 Checking the paper condition in the Paper CassetteIs the paper dry and recommended paper? Go to step 4.Replace the paperwith a new dry andrecommendedone, then go tostep 3.3 Checking noise when the paper is fed from the Tray 1Does the noise arise from the printer? Go to step 4. End of work.4Checking the SEPARATOR ROLLER ASSEMBLY in thePaper Cassette for rotationRemove the Paper Cassette from the printer.Does the SEPARATOR ROLLER rotate smoothly?Turning it with your finger.Go to step 5.Replace theSEPARATORROLLERASSEMBLY.(Refer to Removal2/ Replacement58.)5Checking the ROLL ASSY FEED for rotationRemove the Paper Cassette from the printer.Checked by [Digital Output]-[DO-00 and 2F] of the [IOTDiag] on the [Printer] of the diagnosis.Does the noise arise from this Roller?NOTE: After checking is completed, turn off DO-2F first,and then turn off [DO-00].Replace the ROLLASSY FEED.(Refer to Removal4/ Replacement56.)Go to step 9.6Checking the paper guide sides setting and paper setting ofSSFWere the paper guide sides of SSF correctly set, and wasthe paper correctly inserted into SSF?Go to step 7.Reset the paperguide sides, andcorrectly insert thepaper to SSF, thengo to step 7.7 Checking the paper conditionIs the paper dry and recommended paper? Go to step 9.Replace the paperwith a new dry andrecommendedone, then go tostep 8.8 Checking noise when the paper is fed from the SSFDoes the noise arise from the printer? Go to step 9 End of work.9Checking the Main MotorDoes the noise arise from the printer?Checked by [Digital Output]-[DO-00] of the [IOT Diag] on the[Printer] of the diagnosis.Go to step 10. Go to step 16.
