1 - 407Chapter 1 TroubleshootingVersion 1 2008.02.01FIP-1.P13 Paper damageTrouble substanceThe paper comes out from the printer wrinkled, folded or worn-out.Possible causative parts- SEPARATOR ROLLER ASSEMBLY (PL2.1.5)- ROLL ASSY FEED (PL3.2.4)- ROLL ASSY REGI (PL3.2.9)- ROLL REGI METAL (PL3.2.10)- KIT IIT ASSY SUB (PL10.9.99)- ADF ASSY (PL10.10.1)- KIT ADF FEED ROLL and SEPARATOR PAD (PL10.10.97).Tray is recommended for paper feeding because sheets fed via SSF is prone toskew depending on how the sheet is placed on SSF.Before commencing troubleshooting, check the paper transfer path. Make sure there is no foreignmaterials on the transfer path, such as staples, paper clips, scraps of paper and so on.Step Check RemedyYes No1 Checking the error modeDoes the error occur when feeding the original at the ADF? Go to step 2. Go to step 5.2 Checking the originalDoes the original meet the ADF spec.? Go to step 3.Use the PlatenMode or changethe original.3Checking the ADF Guides settingReseat the ADF Guides.Does the error still occur when copying?Go to step 4. End of work.4Checking the ADF Feed Roller and the Separator PadAre there any damages or foreign substances on the Rollerand Pad?Replace the KITADF ROLL andSEPARATORPAD. (Removal57/Replacement4)Replace the ADFASSY. (Removal59/Replacement2)5Checking dew condensationWas the printer installed in the room where the airconditioner well works?Go to step 7.Turn on the powerof the airconditioner, andreplace a newdray andrecommendedpaper, then go tostep 6.6 Is the image printed correctly? End of work. Go to step 7.7 Checking the using paperDoes the using paper meet the specifications? Go to step 9.Use the paper thatmeets thespecifications,then go to step 8.8 Is the image printed correctly? End of work. Go to step 9.Mnt01117KA
