1 - 195Chapter 1 TroubleshootingVersion 1 2008.02.15FIP1.17 009-362 Restart PrinterStep Check Yes NoPossible causative parts:CARTRIDGE ASSY (C) (PL5.1.19)HARN ASSY CRUM (PL10.1.13)CONNECTOR CRUM (PL5.1.3)PWBA MCU (PL9.1.20)1 Checking the CARTRIDGE ASSY (C) for installationIs the CARTRIDGE ASSY (C) installed correctly? Go to step 3.Reseat the CAR-TRIDGE ASSY(C), then go tostep 2.2 Does the error still occur when the power is turned ON? Go to step 3. End of work3 Checking the CONNECTOR CRUM for installationIs the CONNECTOR CRUM installed correctly? Go to step 4.Reseat the CON-NECTOR CRUM,then go to step 4.4Checking the connectors for connectionCheck the connections between the PWBA MCU andCONNECTOR CRUM.Are P/J31 and P/J 313 connected surely?Go to step 5.Reconnect theconnector(s)P/J31 and/orP/J 313 surely,then go to step 5.5Checking the HARN ASSY CRUM for continuityDisconnect P/J31 from the PWBA MCU.Disconnect P/J313 from the CONNECTOR CRUM.Is each cable of P/J31 <=> P/J313 continuous?Go to step 6.Replace theHARN ASSYCRUM.6 Checking the CONNECTOR CRUM for shapeIs there any damage on the CONNECTOR CRUM?Replace theCONNECTORCRUM.Go to step 7.7Checking after replacing the CONNECTOR CRUMReplace the CONNECTOR CRUM.Does the error still occur when the power is turned ON?Go to step 8. End of work8Checking after replacing the CARTRIDGE ASSY (C)Replace the CARTRIDGE ASSY (C).Does the error still occur when the power is turned ON?Replace thePWBA MCU.(Refer to Removal30/Replacement14)End of work
