3 - 57Chapter 3 Removal and Replacement Procedures (RRPs)Version 1 2008.01.08Removal 32 FAN (PL9.1.10)Steps 1 through 6 are for reference. Before removing this component, check that Steps 1 through 6have been performed.1) Open the FRONT COVER (PL1.2.1).2) Remove the FUSER. (Removal 8)3) Remove the REAR COVER. (Removal 10)4) Remove the RIGHT COVER. (Removal 11)5) Remove the LEFT COVER. (Removal 20)6) Remove the TOP COVER. (Removal 31)7) Disengage the connector (P/J503) of the FAN (PL9.1.10) on the LOW VOLTAGE POWERSUPPLY (PL9.1.4).8) Remove the harness of the FAN by releasing the clamps.9) Release the harness of the FAN from the hook of the printer.10) Remove the two screws (silver, 30mm) that fix the FAN to the printer.11) Remove the FAN from the printer.Zna03044KA11)7)9)10)10)8)8)
