1 - 309Chapter 1 TroubleshootingVersion 2 2008.03.27FIP-1.P12 SkewTrouble substanceThe printed image is not paralleled with both sides of the paper.Possible causative parts- SEPARATOR ROLLER ASSY MSI (PL2.1.3)- KIT SEPARATOR and FEED ROLLER (PL2.2.99)- ROLL ASSY FEED MSI (PL3.1.10)- KIT FEEDER ASSY (PL3.2.99)- TRANSFER ASSY (PL4.1.1)- FEEDER ASSY DUP (PL11.1.1)- KIT SEPARATOR and FEED ROLLER (PL12.3.99)Before commencing troubleshooting, check the paper transfer path. Make sure there is no foreignmaterials on the transfer path, such as staples, paper clips, scraps of paper and so on.Step Check Yes No1 Checking the paper conditionIs the paper in the tray new and dry one?Replace thepaper with a newand dry one.Go to step 2.2Checking the Front Cover latchingOpen and close the Front Cover.Does the error still occur when printing?Go to step 3. End of work.3Checking the foreign substanceOpen the Front Cover, check the surrounding area of theprint cartridges, the TRANSFER ASSY and the Regi Rolls.Are there any foreign substances?Remove the for-eign substances. Go to step 4.4Checking the surface of TRANSFER ASSY.Are there any damages on the surface of TRANSFERASSY?Replace theTRANSFERASSY. (Refer toRemoval 4/Replacement 40)Go to step 5.5 Checking the skewed trayIs the skewed paper the MPF fed? Go to step 6. Go to step 12.6Checking the paper installation. Reseat the paper andreset the paper guide on the MPF.Does the error still occur when printing?Go to step 7. End of work.7 Checking the paperIs the MPF feeding the envelope? Go to step 8. Go to step 9.8Checking the envelope settingWas the envelope inserted with the flap closed, air vacu-umed, and short edge facing toward the printer?Go to step 9. Reseat the enve-lopes.9 Checking the paper path.Is there the foreign substance on the paper path?Remove the for-eign substance. Go to step 10.Mnt01116KA
