Menu Item DescriptionFailsafe Baud Rate Displays the failsafe baud rate for console redirection. The BIOS attempts todetermine the baud rate automatically. This failsafe baud rate is used only if theattempt fails and the value must not be changed. By default, the Failsafe Baud Rateoption is set to 11520.Remote TerminalTypeAllows you to set the remote console terminal type. By default, the RemoteTerminal Type option is set to VT 100/VT 220.Redirection AfterBootAllows you to enable or disable to the BIOS console redirection when theoperating system is loaded. By default, the Redirection After Boot option is set toEnabled.System profile settings screenMenu Item DescriptionSystem Profile Allows you to set the system profile. If you set the System Profile option to a modeother than Custom, the BIOS automatically sets the rest of the options. You canonly change the rest of the options if the mode is set to Custom. By default, theSystem Profile option is set to Performance Per Watt Optimized (DAPC). DAPC isDell Active Power Controller.NOTE: The following parameters are available only when the System Profile isset to Custom.CPU PowerManagementAllows you to set the CPU power management. By default, the CPU PowerManagement option is set to System DBPM (DAPC). DBPM is Demand-BasedPower Management.MemoryFrequencyAllows you to set the memory frequency. By default, the Memory Frequencyoption is set to Maximum Performance.Turbo Boost Allows you to enable or disable the processor to operate in turbo boost mode. Bydefault, the Turbo Boost option is set to Enabled.C1E Allows you to enable or disable the processor to switch to a minimumperformance state when it is idle. By default, the C1E option is set to Enabled.C States Allows you to enable or disable the processor to operate in all available powerstates. By default, the C States option is set to Enabled.Monitor/Mwait Allows you to enable Monitor/Mwait instructions in the processor. By default, theMonitor/Mwait option is set to Enabled for all system profiles, except Custom.NOTE: This option can be disabled only if the C States option in Custommode is disabled.NOTE: When C States is enabled in Custom mode, changing the Monitor/Mwait setting does not impact system power/performance.Memory PatrolScrubAllows you to set the memory patrol scrub frequency. By default, the MemoryPatrol Scrub option is set to Standard.22