IPv6 Routing | 555Telnet with IPv6IPv6 Telnet is supported on platforms c e sThe Telnet client and server in FTOS support IPv6 connections. You can establish a Telnet session directlyto the router using an IPv6 Telnet client, or an IPv6 Telnet connection can be initiated from the router.SNMP over IPv6SNMP is supported on platforms c e sSimple Network Management Protocol (SNMP) can be configured over IPv6 transport so that an IPv6 hostcan perform SNMP queries and receive SNMP notifications from a device running FTOS IPv6. The FTOSSNMP-server commands for IPv6 have been extended to support IPv6. Refer to the SNMP and SYSLOGchapter in the FTOS Command Line Interface Reference for more information regarding SNMP commands.• snmp-server host• snmp-server user ipv6• snmp-server community ipv6• snmp-server community access-list-name ipv6• snmp-server group ipv6• snmp-server group access-list-name ipv6Note: Telnet to link local addresses is not supported.Command Syntax Command Mode Purposetelnet ipv6 address EXEC orEXEC PrivilegedEnter the IPv6 Address for the device.ipv6 address : x:x:x:x::xmask : prefix length 0-128IPv6 addresses are normally written as eight groups of four hexadecimal digits, whereeach group is separated by a colon (:). Omitting zeros is accepted as described inAddressing earlier in this chapter.
