794 | Port Monitoringw w w . d e l l . c o m | s u p p o r t . d e l l . c o m Figure 36-8. Configuring Flow-based MonitoringFTOS(conf)#monitor session 0FTOS(conf-mon-sess-0)#flow-based enableFTOS(conf)#ip access-list ext testflowFTOS(config-ext-nacl)#seq 5 permit icmp any any count bytes monitorFTOS(config-ext-nacl)#seq 10 permit ip 102.1.1.0/24 any count bytes monitorFTOS(config-ext-nacl)#seq 15 deny udp any any count bytesFTOS(config-ext-nacl)#seq 20 deny tcp any any count bytesFTOS(config-ext-nacl)#exitFTOS(conf)#interface gig 1/1FTOS(conf-if-gi-1/1)#ip access-group testflow inFTOS(conf-if-gi-1/1)#show config!interface GigabitEthernet 1/1ip address 10.11.1.254/24ip access-group testflow inshutdownFTOS(conf-if-gi-1/1)#exitFTOS(conf)#do show ip accounting access-list testflow!Extended Ingress IP access list testflow on GigabitEthernet 1/1Total cam count 4seq 5 permit icmp any any monitor count bytes (0 packets 0 bytes)seq 10 permit ip 102.1.1.0/24 any monitor count bytes (0 packets 0 bytes)seq 15 deny udp any any count bytes (0 packets 0 bytes)seq 20 deny tcp any any count bytes (0 packets 0 bytes)FTOS(conf)#do show monitor session 0SessionID Source Destination Direction Mode Type--------- ------ ----------- --------- ---- ----0 Gi 1/1 Gi 1/2 rx interface Flow-based
